A Guide to Windshield Replacement Aftercare

Windshield glass can break if a flying stone hits it hard enough. It is annoying to fix the chips, but it is necessary. Because otherwise it will turn into a big crack and before you know it, you will have to replace the entire windshield.

After replacing your windshield, it is important to follow aftercare procedures for long-term positive results and maximum safety.

One hour after the windshield is replaced, you will need to:

1. Wait an hour before driving.

An adhesive is used to hold the new windshield in place so that a strong, waterproof seal is created around it. You should wait to drive the car at least an hour after installation, that way you will give the stamp enough time to dry and dry properly. And in case you forget this, your technician will surely remind you right after your windshield is replaced.

A day or two after the window replacement process is complete, you will need to:

2. Clear the vehicle inside and out.

After a day the seal is dry enough that you can drive your car. However, it is not completely dry yet. So you need to prevent things from sticking to the stamp. For this reason, be sure not to cover the exterior of the vehicle with any type of covering. It is recommended not to use an umbrella and make sure the board is clutter-free.

3. Open a window.

The windshield does not reach its maximum strength while it dries, so it is best to avoid stress during the first day or two. Increased air pressure causes additional stress around the windshield. To prevent future leaks, roll down a window at least one inch, especially the first day after installation.

4. Leave the retention tape on.

Retaining tape is used to hold the windshield trim in place. Protect the stamp while it is still drying. Therefore, it is best not to remove the tape for a day or two after installation, even if it is a nuisance to the eyes.

5. No pressure washers or car washers allowed for the first two days.

The new windshield takes at least two days to fully dry and settle. During this time, you should avoid automatic and high-pressure washes to protect the new trim.

The best way to protect glass and clean it at the same time is to hand wash it.

6. Protect the new glass from unnecessary stress.

While fixing the new glass, be careful with your car doors, so do not hit them and try to stay away from the roads with many potholes and potholes.

Find a trusted windshield replacement expert

You will need to pay a little extra care and attention to maintain a new windshield. That way, you can extend the life of your car glass and reduce the need for costly repairs in the future.

Hopefully, these tips will help you take good care of your windshield.

Leave a Reply

Your email address will not be published. Required fields are marked *